Tough Prime Stage Floor Paint – Specs, Application & Coverage
Specs, application and how much you will need
The practical detail, so you can spec it, put it down properly and work out the right amount.
Technical specifications
| Finish | Egg-shell (black) |
|---|---|
| Type | Water-based acrylic scenic primer and sealer |
| Binder | Acrylic polymer |
| Coverage | Approx. 28 m² per 3.8 L per coat (300 sq ft per US gallon), depending on substrate and method |
| Film thickness | 3 mil dry film (approx. 76 micron) |
| Dry time | Touch dry 30–45 min; recoat in 1–2 hours at 24°C |
| Clean-up | Soap and water |
| Sizes | 3.8 L (1 gallon) and 19 L (5 gallon) |
| Adheres to | Wood (timber, MDF, plywood), metals and aluminium, PVC and plastics, foam, foamcore and muslin |
| Apply with | Brush, roller or spray gun |
Figures per Rosco published data. Coverage varies with surface, porosity and application.
How it goes down
Fast dry times mean more than one coat in a single day, which is why a floor can be resurfaced in a break between shows.
Prepare
Clean, dry and sound. Remove loose or flaking paint, vacuum off dust, and lightly abrade glossy or previously coated areas so it can grip.
Seal porous areas
It is the primer, so no separate undercoat is needed. On very absorbent bare MDF, chipboard or raw ply, a thinned first coat evens out the porosity. Concrete needs proper prep first.
First coat
Lay on a thin, even coat by brush, roller or spray. Thin coats level better and dry harder than one heavy coat.
Recoat the same day
Touch dry in 30 to 45 minutes, recoat in 1 to 2 hours. Two coats suits most floors and both can go on in a day.
Let it cure
Let the finish dry and cure before wagons, equipment and traffic return to the floor. Allow extra time where you can.
Touch up as needed
Later on, scuff the worn area, clean it and recoat. No strip-back, no full repaint unless you want one.
How much will you need?
Based on roughly 28 m² per 3.8 L per coat. Two coats is standard for most stage floors.
Questions about your floor?
We are the exclusive Rosco distributor for Australia and New Zealand. Send us a message or give us a call and we will help you work out whether Tough Prime is right for your stage.