Rosco Clear Sleeve with UV Filter — T8 fluorescent lamp sleeve
A clear polycarbonate sleeve with a UV filter for T8 fluorescent lamps, supplied with two end caps that hold the lamp in place and help contain glass if the lamp breaks.
Image: Rosco
UV reduction and lamp protection
Rosco’s T8 sleeves include a UV filter that transmits less than 10% of light below 390 nm. The end caps fit snugly over the lamp ends to keep a broken lamp’s glass contained.
- Reduces UV from fluorescent lamps
- Helps contain glass if a lamp breaks
- End caps hold the lamp in place
- Clear — no colour shift intended
- Clear polycarbonate tube
- Can be cut to length with scissors (per Rosco)
Displays, studios and venues
Museums, galleries & retail
Reduce UV on displays and stock lit by fluorescent tubes.
Studios & sets
Protect fluorescent practicals and fittings on set.
Venues & workspaces
Lamp protection where breakage would be a problem.
What it is — and what it isn’t
Use it for
- Standard T8 fluorescent lamps
- Reducing UV on displays and artwork
- Containing glass from broken lamps
- Matching lengths 60, 90, 120 and 150 cm
Don’t use it for
- HO or VHO lamps — heat can exceed the plastic’s limits
- T5 or T12 lamps — choose the matching sleeve size
- Adding colour — use a RoscoSleeve with colour filter
- LED tubes, unless the tube maker approves sleeve use
Getting the best result
- Switch off and let the lamp cool, then remove it from the fitting.
- Slide the sleeve over the lamp.
- Fit an end cap over each end.
- Refit the lamp and check it seats correctly.
- Check sleeves during maintenance for discolouration or damage.
Key details
| Product | Rosco Clear Sleeve with UV Filter and End Caps |
|---|---|
| Lamp size | T8 |
| Lengths | As listed above (60, 90, 120 and 150 cm) |
| T8 sleeve diameter (per Rosco) | OD 1.22 in (approx. 31 mm), ID 1.18 in (approx. 30 mm) |
| UV filter (per Rosco) | Transmits less than 10% of light below 390 nm |
| Material | Clear polycarbonate |
| End caps | 2 included |
| Not for | HO / VHO lamps |
Common questions
Does the sleeve block all UV?
No. Rosco says the UV filter transmits less than 10% of light below 390 nm. It reduces UV but doesn’t eliminate it.
Can I use it on HO or VHO lamps?
No. Rosco advises against it — the heat from HO/VHO lamps can exceed the plastic’s limits.
What do the end caps do?
They fit over the lamp ends and hold the lamp in place, so glass stays inside the sleeve if the lamp breaks.
Can I cut the sleeve to length?
Rosco says sleeves can be cut with scissors. Measure carefully and fit the end caps after cutting.
Do you have coloured sleeves?
Yes — RoscoSleeves can be ordered with a Rosco colour filter inside.
Check your lamp type and length before ordering, and follow the fitting maker’s instructions. Information is from Rosco product data and is a guide only.
Need help choosing?
Tell us what you’re working on and we’ll point you to the right product for the job.
